Ethereum order flow, live and free.
Yes. Basis builds a free, live ETH footprint chart from Binance’s ETHUSDT perpetual trade tape: bid and ask volume at every price, delta, POC and stacked imbalances, beside a live liquidity heatmap and the tape, with no account, no trial and no card.
ETH on Binance right now
ETHUSDT perpetual · measured 2026-11-02 16:15 UTC from Binance public market data · refreshed every few hours
- 24h volume
- $6.24B
- Trades a second
- 38
- Average trade
- $2K
- Spread
- 0.04 bps
- Depth within ±0.5%
- $119M
- 1,000-level reach
- ±0.49%
- Typical 15-min move
- 0.23%
- Funding (last)
- +0.0025%
- Open interest
- $5.35B
- Listed on Binance futures
- November 2019
Settings that fit ETH
- 1
Footprint interval: 1m
Start on 1m. ETH prints about 38 trades a second on Binance, so a one-minute bar holds roughly 2,300 trades and a first screen of 15 bars loads in 29 seconds. 5m adds context but needs about 2 minutes to load its first screen.
- 2
Row grouping
A typical one-minute ETH bar spans about 138 ticks of 0.01. Leave row grouping on Auto, which merges rows until the figures fit, and raise it if a bar still reads as a wall of single ticks.
- 3
Heatmap: use the 5m view
Use the 5m heatmap view. ETH’s nearest 1,000 levels reach about 0.49% from price, 2.1 times its typical fifteen-minute move of 0.23%. Fit stretches to fifteen minutes, and a fast move can carry price beyond what was recorded, leaving grey above or below.
What you get, free
- A live Volume footprint on ETHUSDT: Bid × Ask, Delta, Volume and Dominance views, with row grouping tuned to ETH’s tick of 0.01
- Delta, bar POC and value area, stacked imbalances and delta divergence, built from Binance’s exact trade-at-price tape
- The Order Flow workspace for ETH: a live liquidity heatmap, depth of market and Time & Sales on the same contract
- Funding and open interest in the derivatives panel, and reported liquidations marked on the order-flow timeline
- Replay of past sessions bar by bar, and price alerts that run while the tab is open
Reading Ethereum’s order flow
Ethereum combines large-cap market beta with smart-contract, staking and scaling narratives, so ETH/BTC is essential context beside ETH/USDT.
What to ask of the flow: Is this market setting the crypto regime, confirming it, or diverging from it? Use spot participation, accepted value and derivatives positioning together; one green candle is not regime confirmation.
The common mistake: Treating the benchmark as isolated from liquidity, macro conditions or cross-market positioning. Network, staking and regulatory catalysts can create ETH-specific divergence while traders assume it will continue following Bitcoin.
Questions
Is the ETH footprint chart really free?+
Yes. Every crypto footprint in Basis is free, ETH included: no account, no trial and no card. Open the link and Basis builds the ETHUSDT footprint from Binance’s live trade tape, with delta, POC, imbalances, the liquidity heatmap and Time & Sales.
Which ETH market does Basis use for order flow?+
Binance’s ETHUSDT USD-M perpetual, the contract the figures on this page describe. Footprints are built from Binance trades only, so they show trading on Binance rather than on every venue that lists ETH, and no other venue’s chart is filled with Binance trades.
What interval should I use for the ETH footprint?+
Start on 1m. ETH prints about 38 trades a second on Binance, so a one-minute bar holds roughly 2,300 trades and a first screen of 15 bars loads in 29 seconds. 5m adds context but needs about 2 minutes to load its first screen.
Why does the ETH heatmap show grey areas?+
Grey is depth that was not recorded, never an empty book. Binance publishes no order-book history, so Basis records the ETHUSDT book from the moment you open it and keeps fifteen minutes. Use the 5m heatmap view. ETH’s nearest 1,000 levels reach about 0.49% from price, 2.1 times its typical fifteen-minute move of 0.23%. Fit stretches to fifteen minutes, and a fast move can carry price beyond what was recorded, leaving grey above or below.
Can I see ETH order flow for other exchanges?+
Not as a footprint. Trade-at-price data in Basis is built from Binance only, and Binance trades are never borrowed to decorate another venue’s chart. Bybit, OKX and Hyperliquid charts in Basis show their own candles and derivatives data instead of a footprint.
Open ETH and see
The chart opens on the ETHUSDT footprint at 1m. Press Order Flow at the top for the heatmap, depth and tape. Nothing to configure, nothing to sign up for.
Open the chartOrder flow for other coins
Figures describe Binance’s ETHUSDT perpetual only, measured 2026-11-02 16:15 UTC. Settings are starting points derived from them, not advice to trade. All free tools · Order flow docs · Terminal